Home   Forums   Gallery   Vendors   Advertising   Links
Go Back   DieselRam.com > Diesel Ram Technical Topics > NEW! How To and Product Review Info:
NEW! How To and Product Review Info: New! A collection of user generated articles and "how to" information pertaining to the Dodge CTD! A great resource, and one that is unique to dieselram!
Closed Thread
 
Thread Tools Search this Thread
  #1  
Old 02-19-2008
MAXTORQ's Avatar
MAXTORQ MAXTORQ is offline
Administrator
 
Join Date: Jan 2004
Location: GOLDEN ,COLORADO
Posts: 19,635
Send a message via Yahoo to MAXTORQ Send a message via Skype™ to MAXTORQ
Default APPS adjustment

Instructions:

APPS location varies ,it can be mounted at the drivers side front of the intake plenum or mounted beneath the drivers side battery.

Tools: Digital Volt Meter, T-20 Torx bit, #1 phillips, 10mm socket

With the key on, engine off you need to probe the APPS wire to see where the voltage is currently set at.
The best location to probe the wire is on the PCM (Power Control Module) which is located on the passenger firewall behind the air intake.
You want the C1 connector, this is the connector closest to the engine
You want the orange wire with a dark blue tracer which is pin #23 (Please use a suitable backprobing adapter for your meter lead, do not pierce the insulation as this can lead to water intrustion/corrosion.)
Voltage should be somewhere around 0.5 volts,
At this point the voltage reading does not matter, it just has to be accurately written down for later reference

TURN THE IGNITION OFF ON THE TRUCK

Remove the black plastic cover off of your APPS. There are two plastic screws. One on the top and one on the front facing the radiator. It takes a little prying to pull it off.

Undo the 6-10mm bolts that hold the bracketry in place but DO NOT REMOVE THE CABLES!!

You will notice the APPS is on the back of the bracketry that you just removed, it is held in place by 2-T20 torx bit screws. These screws have a little bit of locktite on them so make sure you have a good socket and gently give a little tap with a hammer before attempting to loosen. Be very careful because these screws strip VERY easily and you only get one shot at them (VERY VERY VERY IMPORTANT; They are VERY tight).

On the APPS you will find a white tag that gives you the information on what the APPS voltage should be.
After loosening the screws (do not remove) you can rotate the APPS clockwise or counter clockwise to get the adjustment (towards the front of the truck increases voltage and towards the rear of the truck decreases voltage)
The reading you took at the beginning of the process on pin #23 should match the white tag on your APPS. If it doesn't the adjust accordingly.
__________________


www.maxtorqdiesel.com
Closed Thread

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 12:05 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2016 www.dieselram.com. All material found on this site is property of DieselRam.com.Ad Management plugin by RedTyger