Home   Forums   Gallery   Vendors   Advertising   Links
Go Back   DieselRam.com > Search Forums
Showing results 1 to 25 of 284
Search took 0.02 seconds.
Search: Posts Made By: streeter
Forum: Technical Info: 3rd Generation: DRIVETRAIN 06-23-2017
Replies: 2
Views: 262
Posted By streeter
mushy clutch pedal

Just installed new clutch (3rd), did not replace the master/slave (on 3rd there as well). After both master/slave installs pedal was a little mushy for a while and engage point a bit off, but...
Forum: Technical Info: 2nd Gen 24 VALVE DRIVETRAIN 06-08-2017
Replies: 9
Views: 662
Posted By streeter
slave cylinder possibly? do you have good pedal?

slave cylinder possibly? do you have good pedal?
Forum: Technical Info: 2nd Gen 24 VALVE DRIVETRAIN 05-10-2017
Replies: 6
Views: 385
Posted By streeter
have not used the rear sway bar end links by...

have not used the rear sway bar end links by MAXX, had a pair on the front and one broke, snapped right in two...went with BD's...they are MUCH beefier
Forum: General Diesel 01-23-2017
Replies: 3
Views: 1,071
Posted By streeter
about time...

my '03 just turned 328k and i've been browsing the net a bit in search of something new(er) to me. would like to avoid all the EGR, DEF/DPF, Cat mess. when were the last models made without them? ...
Forum: Technical Info: 3rd Generation: NON-DRIVETRAIN 08-08-2016
Replies: 17
Views: 1,394
Posted By streeter
same year model (@ 317k miles) & equipment except...

same year model (@ 317k miles) & equipment except NV5600. expect upper & lower ball joints, front axle u-joints, hubs/wheel bearings, and tie rods. i've also replaced steering damper with a...
Forum: Technical Info: 3rd Generation: DRIVETRAIN 05-11-2016
Replies: 4
Views: 1,206
Posted By streeter
front drive shaft

will it hurt anything to drive truck without front drive shaft (x-fer case to front diff) in? truck been in shop for major front end work and would like to get out of rental if I can....drive shaft...
Forum: Technical Info: 3rd Generation: NON-DRIVETRAIN 01-08-2016
Replies: 13
Views: 2,123
Posted By streeter
thanks, will likely rebuild it...did the starter...

thanks, will likely rebuild it...did the starter & have it in 'inventory'...goal is min of 500k for this rig so you never know...

speaking of mileage...now that i'm north of 300k anything I need...
Forum: Technical Info: 3rd Generation: NON-DRIVETRAIN 01-07-2016
Replies: 13
Views: 2,123
Posted By streeter
Alternator?

Any reason to rebuild OEM alternator? Got 304k out of original.

replaced with Ultima reman from OReilly w/ lifetime warranty
Forum: General Diesel 07-24-2015
Replies: 10
Views: 1,725
Posted By streeter
don't even smoke much. a few puffs rowing...

don't even smoke much. a few puffs rowing through the gears....damn sure not for 10+ seconds unless I had my foot on the floor
Forum: General Diesel 07-24-2015
Replies: 10
Views: 1,725
Posted By streeter
ever get one of these?

w...tf ??? now I got tree-huggers turning me into the TCEQ?
Forum: Technical Info: 3rd Generation: DRIVETRAIN 07-24-2015
Replies: 6
Views: 1,708
Posted By streeter
NAPA part # for front axle is: PUJ 464...

NAPA part # for front axle is: PUJ 464 (premium/greasable joint)...only one they carried

old NAPA # for rear diff (have one on shelf) is: # 28600188 (heavy duty/greasable), as ccmckee said, MUCH...
Forum: Technical Info: 3rd Generation: DRIVETRAIN 07-17-2015
Replies: 6
Views: 1,708
Posted By streeter
U-joints

can someone tell me if front axle u-joints are same part # as driveshaft u-joints?

don't have part # on me, but last few drive shaft joints I've used the heavy-duty greaseables from NAPA
...
Forum: Technical Info: 3rd Generation: DRIVETRAIN 03-25-2015
Replies: 6
Views: 1,658
Posted By streeter
dirty air filter and/or dirty fuel filter...first...

dirty air filter and/or dirty fuel filter...first places to start
Forum: Technical Info: 3rd Generation: NON-DRIVETRAIN 01-29-2015
Replies: 3
Views: 850
Posted By streeter
not recently, maybe back in summer when I...

not recently, maybe back in summer when I replaced ebrake cable
Forum: Technical Info: 3rd Generation: NON-DRIVETRAIN 01-29-2015
Replies: 3
Views: 850
Posted By streeter
anyone? at a loss here....

anyone? at a loss here....
Forum: Technical Info: 3rd Generation: NON-DRIVETRAIN 01-13-2015
Replies: 3
Views: 850
Posted By streeter
AirBag light / clockspring

Air Bag light had been on so had clockspring replaced; however, that did not cure Air Bag light on issue. Next steps?

Thanks,
Streeter
Forum: Technical Info: 3rd Generation: DRIVETRAIN 05-19-2014
Replies: 10
Views: 1,744
Posted By streeter
got a set of Fast Coolers on my nv5600, can add...

got a set of Fast Coolers on my nv5600, can add 2+ quarts (7+ total) on top of trans fill/level plug. run Amsoil MTF Syncromesh @ 50k intervals comes out clean as it went in
Forum: Technical Info: 3rd Generation: NON-DRIVETRAIN 04-29-2014
Replies: 5
Views: 691
Posted By streeter
try to find bulbs with a glass base vs. a plastic...

try to find bulbs with a glass base vs. a plastic base (contacts melt down into plastic)...I believe NAPA carries them, when I find them I buy several packages

over the years I've had to replace...
Forum: General Diesel 04-29-2014
Replies: 5
Views: 976
Posted By streeter
posted these a few years ago, 4BT 6 wheel drive...

posted these a few years ago, 4BT 6 wheel drive jeep

http://s690.photobucket.com/albums/vv268/streeter9/
Forum: Technical Info: 3rd Generation: DRIVETRAIN 07-23-2013
Replies: 7
Views: 630
Posted By streeter
with turbo & no cat there is little, if any,...

with turbo & no cat there is little, if any, backpressure that typically helps decelerate a gasser once you take your foot out of it....one of the first things I noticed w/ my 6 speed

might try a...
Forum: On The Side 04-18-2013
Replies: 14
Views: 1,307
Posted By streeter
local sportstalk show suggested the government...

local sportstalk show suggested the government sponsor a PPV televising the torture & execution of terrorists (domestic or international)

satisfy our bloodlust and help balance the budget
Forum: On The Side 03-22-2013
Replies: 3
Views: 623
Posted By streeter
Carhartt Makes a Car?

seems odd this package would be in a 200S :dunno:, should be offered in our CTDs! :D

http://www.foxnews.com/leisure/2013/03/22/carhartt-edition-chrysler-200-s-revealed/?intcmp=features
Forum: Technical Info: 3rd Generation: DRIVETRAIN 02-20-2013
Replies: 2
Views: 713
Posted By streeter
bump...any ideas?? when in N or 2H the 4x4 light...

bump...any ideas?? when in N or 2H the 4x4 light comes ON, when in 4L or 4H 4x4 light goes OFF? could this be a bad or malfunctioning position sensor?

seriously bugging me :confused:, would...
Forum: Technical Info: 3rd Generation: DRIVETRAIN 02-19-2013
Replies: 2
Views: 713
Posted By streeter
4x4 light ???

Finally had original clutch replaced yesterday (@ 236k) and they also replaced front output shaft seal on T-case, manual shifter.

Now when in N or 2H the 4x4 light comes on, when in 4L or 4H 4x4...
Forum: Technical Info: 3rd Generation: DRIVETRAIN 02-15-2013
Replies: 2
Views: 709
Posted By streeter
fuel control actuator replacement

when replacing FCA how vital is it to use new hardware & torque specs per DR Srv. Manual?

thanks in advance,
Streeter
Showing results 1 to 25 of 284

 
Forum Jump

All times are GMT -6. The time now is 03:09 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2016 www.dieselram.com. All material found on this site is property of DieselRam.com.Ad Management plugin by RedTyger